![]() ![]() The sound should vanish by little bit tweaking.If it doesn't work then you may consider decreasing the fan speed by using fancontrol Intrusion0: suggest you to check if the hardware installation of fans is correct(either yourself or from some expert). ![]() If you look at the output of sensors command for my dual-core computer and compare it with yours, you'll find that the fan speed your computer is using is keeping your processors cool, which is important.In my case the processor temp are high but fan speed is low. I don't think you need to control fan speed, actually fan should not make much sound even at high speeds. I'm not sure if any of these temps seem high. When I run the sensors command I get the following output. However when I ran pwmconfig it said "There are no pwm-capable sensor modules installed". I ran lm-sensors as sudo, it found some things and I loaded the modules it recommended into the kernel. I followed the instructions on this forum link and configured lm-sensors then attempted to configure fancontrol. No modules to load, skipping modules configuration.Įdge: +37.0☌ (crit = +80.0☌, hyst = +0.0☌) Note: there is no driver for ITE IT8686E Super IO Sensors yet. * Chip `AMD Family 17h thermal sensors' (confidence: 9) Is there another option to control fan speed? I don't even need dynamic speeds, writing "30%" or something to a file is fine.Ĭhip `ITE IT8686E Super IO Sensors' (confidence: 9) Trying to set the SYSFAN speed on a Gigabyte B250M DS3H.Įvery search about linux terminal fan control leads to lm-sensors directions, but it doesn't detect any fans for me and I've even found some dead end threads from 2016 indicating that newer hardware is unsupported. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |